Snom HD101W User Manual page 3

Sip cordless 1-line hotel telephone, sip cordless 1-line wi-fi enabled hotel telephone , sip cordless 1-line handset and charger ,
Table of Contents

Advertisement

result in damage and often requires
extensive work by an authorized
technician to restore the product to
normal operation.
• If the product has been dropped
and the telephone base and/or
handset has been damaged.
• If the product exhibits a distinct
change in performance.
15. Avoid using a telephone (other than
cordless) during an electrical storm.
There is a remote risk of electric shock
from lightning.
16. Do not use the telephone to report a
gas leak in the vicinity of the leak.
Under certain circumstances, a spark
may be created when the adapter is
plugged into the power outlet, or when
the handset is replaced in its cradle.
This is a common event associated with
the closing of any electrical circuit. The
user should not plug the phone into
a power outlet, and should not put a
charged handset into the cradle, if the
phone is located in an environment
containing concentrations of flammable
or flame-supporting gases, unless there
is adequate ventilation. A spark in such
an environment could create a fire or
explosion. Such environments might
include: medical use of oxygen without
adequate ventilation; industrial gases
(cleaning solvents; gasoline vapours;
etc.); a leak of natural gas; etc.
17. Only put the handset of your telephone
next to your ear when it is in normal talk
mode.
18. The power adapters are intended to be
correctly oriented in a vertical or floor
mount position. The prongs are not
designed to hold the plug in place if it is
plugged into a ceiling, under-the-table
or cabinet outlet.
19. Use only the power cord and batteries
indicated in this manual. Do not dispose
of batteries in a fire. They may explode.
Check with local codes for possible
special disposal instructions.
20. In wall mounting position, make sure to
mount the telephone base on the wall
by aligning the eyelets with the mounting
studs of the wall plate. Then slide the
telephone base down on both mounting
studs until it locks into place. Refer to
the full instructions in Installation in the
user's manual.
21. This product should be mounted at a
height of less than 2 meters.
22. Listed PoE (The product is considered
not likely to require connection to an
Ethernet network with outside plant
routing).
CAUTIONS
• Keep small metallic objects such as
pins and staples away from the handset
receiver.
• There may be a risk of explosion if a
wrong type of handset battery is used
(HD101, HD101W and HD1). Use only
the supplied rechargeable battery (Ni-
MH AAA 550mAh 2.4V) or replacement
battery. Dispose of used batteries
according to the instructions.
SAVE THESE INSTRUCTIONS
EN - 3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sip seriesHd101Hd1

Table of Contents