Snom HD101W User Manual page 9

Telephone base installation
The telephone comes ready for desktop use.
1. Install the telephone base as shown
below.
2. When the telephone base has been initially
installed, make sure the power adapter
is securely plugged into an outlet not
controlled by a wall switch, and the network
cable is plugged into the network wall jack.
3. Bend a small paper clip and gently insert it
to the Handset battery ON pinhole to turn
on the handset.
• Without turning on the battery, the handset
cannot be charged or operate.
• The battery is fully charged after 16 hours of
continuous charging. For best performance,
keep the cordless handset in the telephone
base when not in use.
/SPEAKER on the telephone base.
4. Press
Listen for a dial tone, and then press
SPEAKER again to hang up.
Note
• The dial tone will not be played if the SIP
account used by this phone cannot be
registered.
• The adapter sold separately.
CAUTIONS
Use only the supplied cable and specified
power adapter. The supplied cable is not
designed for use in any other IT devices.
Misusing it on your other IT devices shall be
prohibited. To order a replacement, contact
authorized service personnel, your seller, or
Snom.
EN - 9
/