Table of Contents
Advertisement
What to do if ...
33
Changing the bulb for interior lighting
Only use a special bulb which is designed specially for dryers. The special bulb can
be obtained from the Customer Care Department, part no. 11255200/.
When the appliance is switched on, the interior lighting switches itself off after 4
minutes when the door is open.
WARNING!
Do not use standard bulbs! These develop too much heat and may damage the
machine!
WARNING!
Before replacing the bulb, disconnect the mains plug.
1. Unscrew cover above the bulb (this can be found directly behind the loading
aperture, at the top; refer to "Description of machine" section.)
2. Replace defective bulb.
3. Screw cover back down.
Check the correct positioning of o-ring gasket before screwing back the door light
cover. Do not operate the dryer when missing o-ring gasket on door light cover.
WARNING!
For safety reasons, the cover must be screwed down tightly. If this is not done, the
dryer must not be operated.
Advertisement
Table of Contents
