Cleaning And Maintenance - Vitek Manual instruction Manual Instruction

Hide thumbs

Table of Contents

Available languages

ENGLISH

Step 4 – cutting the crown of the head

Using the 9 mm attachment comb (7) or 12 mm attachment

comb (8), cut the hair on the top of the head towards the

crown against the hair growth direction.

• You can cut hair against and along the direction of hair

growth, but keep in mind that the hair cut against the

growth will be shorter than the hair cut along the growth.

• Use the 3 mm attachment comb (5) and 6 mm attach-

ment comb (6) for very short haircut. To leave longer

hair, use the necessary 9 mm comb (7) or 12 mm attach-

ment comb (8).

• To leave longer hair, grip hair locks between your fingers

and cut the hair off using the clipper (pic. 5).

• You can use the comb (9): lift the hair locks and cut them

with the hair clipper above the comb (pic. 6).

• Always start cutting from the back of the head.

• Comb the hair with a comb (9) to reveal uneven locks.

• Use the scissors (10) to make haircut even.

Step 5 – the final part

– In the final stage of hair cutting remove the attachment

comb from the unit, turn the blades of the clipper to-

wards the hair and trim hair on the temples and neck

carefully. Do not press the clipper strongly, there is dan-

ger of injuries or cuts when open blades come in contact

with skin (pic. 7).

– Having finished cutting hair, put the protective cover (4)

on the blades block (3).

Cone-shaped haircut

Set the necessary attachment comb and start cutting from

the head back towards the crown. Cut hair against hair

growth from the head front to the crown and from the sides

(pic. 8). To get a flat top haircut, use the comb (9): lift the

locks and cut them along the comb. Comb the hair to detect

uneven locks.