Wireless Networking Application (Ap, Sta) - Waveshare UART-WIFI232-B2 User Manual

UART-WIFI232-B2 User Manual
AT+Z
Complete parameter settings.
Precautions:
When the AP+STA function is enabled, the STA port needs to be connected to other routers.
Otherwise, the STA port will constantly scan the router, which will have a certain impact on the AP
port, such as data loss. If the user determines that the STA cannot connect to the AP at this time, he
can use the command to stop scanning the STA port:
AT+STTC=on/off
"On" means to scan the router, and "off" means not to scan. This command will not be saved
after restarting.
AT+FSTTC=on/off
This command can be saved and will take effect after restarting.
The whole AP+STA application can also refer to our official website
FAQ:http://www.waveshare.com/Faq/45.html
Web Page Configuration: Access the built-in web page, navigate to the wireless terminal settings
page, and enable the AP+STA functionality to configure AP+STA settings.
As shown in the figure:

5.2.4 WIRELESS NETWORKING APPLICATION (AP, STA)

The UART-WIFI232-B2 device's wireless functionality can be configured in two modes: as a
wireless Station (STA) or as an Access Point (AP). Logically, it supports two wireless interfaces: one
Figure Wireless networking application (AP+STA)
35
www.waveshare.com