Product Networking Application; Wireless Networking Settings - Waveshare UART-WIFI232-B2 User Manual

UART-WIFI232-B2 User Manual

5. PRODUCT NETWORKING APPLICATION

The UART-WIFI232-B2 serial server can be configured as either a wireless STA or an AP. So
UART-WIFI232-B2 logically supports two wireless interfaces, one as an STA and the other as an AP.
Other STAs can be connected to the wireless network through the AP interface of this serial server. At
the same time, the UART-WIFI232-B2 serial server provides a 100M Ethernet interface, through which
users can achieve interworking of WIFI, serial port, and Ethernet port. In terms of networking,
UART-WIFI232-B2 serial server supports bridging mode and routing mode to correspond to different
specific applications.
The UART-WIFI232-B2 serial server supports two communication methods: wireless WIFI and
wired Ethernet, providing a very flexible networking method and network topology.
<Note>:
AP: Wireless access point, which is the central node of a wireless network. The commonly used
wireless router is an AP, and other wireless terminals can connect to each other through the AP.
STA: refers to a wireless station, which is a terminal of a wireless network. Such as notebook
computer, PDA, etc.

5.1 WIRELESS NETWORKING SETTINGS

The relevant AT commands are as follows:
Item
1 WMODE
2 WSSSID
3 WSKEY
4 WANN
5 WSLK
6 WAP
7 WAKEY
8 LANN
9 FAPSTA
Figure Batch Parameter Configuration Page
AT
Table wireless networking
Note
Set/query WIFI operation mode (AP, STA)
Set/query the SSID of the associated AP.
Set/query the encryption parameters in WIFISTA
mode.
Set/query the network parameters of STA.
Query the wireless connection status of STA
Set/query parameters in WIFIAP mode.
Set/query the encryption parameters in WIFIAP
mode.
Set/query module IP in AP mode
Enable/disable module AP+STA mode
related command
Table Socket AT
29
command list
list
www.waveshare.com