Table of Contents
Advertisement
UART-WIFI232-B2 User Manual
4. PRODUCT PARAMETERS SETTING
The UART-WIFI232-B2 serial server supports AT command and Web parameter setting. For the
setting of AT command, please refer to the chapter of "AT instruction set" in the document. This
chapter mainly explains how to set up the Web.
4.1 WEB MANAGEMENT PAGE
When using UART-WIFI232-B2 serial server for the first time, it is necessary to configure the WIFI
serial server. You can connect the AP interface of UART-WIFI232-B2 through a PC and configure it
with a web management page.
By default, the AP interface SSID of UART-WIFI232-B2 is Waveshare_xxxx, and the IP address,
user name and password are as follows:
4.1.1 OPEN THE MANAGEMENT PAGE
Firstly, connect UART-WIFI232-B2 with the wireless network card of PC, and the SSID is
Waveshare_xxxx. When connected, open the browser, enter 10.10.100.254 in the address bar and
press enter. Fill in the user name and password in the pop-up dialog box, and then "confirm".
Then; The UART-WIFI232-B2 management page supports Chinese and English, and can be set in
the upper right corner. It is divided into 9 pages, namely, quick configuration, mode selection,
Table Network Default Settings
Specifications
Default
SSID
Waveshare_xxxx
IP Address
10.10.100.254
subnet mask
255.255.255.0
user name
admin
password
admin
Figure the second step of opening the management web page
17
www.waveshare.com
Advertisement
Table of Contents
