Wireless Networking Application (Ap+Sta) - Waveshare RS232/485 TO WIFI POE ETH (B) User Manual

RS232/485 TO WIFI POE ETH (B) User Manual
AT+WMODE=STA
(2) Set the SSID, encryption mode algorithm and password of the router to be connected
(assuming that the routing SSID in the above figure is: Waveshare-TEST, encryption mode algorithm:
WPA2PSK,AES, password: Waveshare), set as follows:
AT+WSSSID=Waveshare-TEST
AT+WSKEY=WPA2PSK,AES,Waveshare
(3) Restart the WIFI serial server:
AT+Z
Complete the parameter setting.

5.2.3 WIRELESS NETWORKING APPLICATION (AP+STA)

The RS232/485 TO WIFI POE ETH (B) serial server can support both an AP interface and an STA
interface. When the AP+STA function is enabled, both the STA and AP interfaces are available. The
STA interface of the serial server is connected with the router and connected with the server in the
network through TCPB; At the same time, the AP interface can be connected by mobile phone /PAD
(through TCPA connection). In this way, the servers in the network, such as TCPServer and mobile
phone /PAD, can control the serial devices connected to the RS232/485 TO WIFI POE ETH (B) serial
server or set the parameters of the serial server itself, as shown in the following figure:
The parameters of WIFI serial server are set as follows:
(1) Enable WIFI serial server AP+STA function
AT+FAPSTA=on
(2) Effective after restoring factory settings
Figure Wireless networking application (AP+STA)
33
www.waveshare.com