Registration Packet Function - Waveshare UART-WIFI232-B2 User Manual

UART-WIFI232-B2 User Manual
If no setting command is received within 30 seconds after UART-WIFI232-B2 enters configuration
mode, UART-WIFI232-B2 will exit configuration mode, and the user needs to resend the search
command word to enter configuration mode.
3. Users can set and read parameters/states by sending network AT commands to this port. The AT
command format is the same as the serial port AT command.
Note: The search tool and UART-WIFI232-B2 must be on the same LAN. If multiple STAs are
connected to a router, the computer running the search tool is also connected to that router. This
search tool can find all the STAs.

6.9 REGISTRATION PACKET FUNCTION

This function only applies to UART-WIFI232-B2 as TCPClient.
The function of registered CLOUD is to send a registration package consisting of device ID and
communication password when UART-WIFI232-B2 is connected to the server, and the registration
package information is correct, and the server returns.
Registration success information, UART-WIFI232-B2 access to transparent cloud platform.
The USR (User-defined Registration Package) function allows users to customize the content of
the registration package, and the length is limited to 40 characters (supported in UDPClient mode,
and the user-defined registration package is added before each data packet is sent).
There are two ways to register MAC function: one is to send registration information when
connecting to the server for the first time; The other is to add registration information in front of the
data sent each time.
There is only one way to register CLOUD, that is, when connecting to the server, send a
registration package to join Transparent
Cloud.
MAC address xxxxxxxxxxxxxx
MID
Version number
68
www.waveshare.com