ICON PRO-FORM CARBON TLX User Manual page 9

3. Locate the Upright Wire (74) on the right side of
the Upright Base (81). Remove the wire tie (not
shown) securing the Upright Wire to the Upright
Base as shown.
Next, identify the Right Upright (73), and
have a second person hold it near the Upright
Base (81).
See the inset drawing. Locate the wire tie (C)
in the Right Upright (73). Tie the wire tie through
the wire pull (D) on the Upright Wire (74). Next,
feed the Upright Wire into the Right Upright, and
pull the upper end of the wire tie until the Upright
Wire is routed through the Right Upright. Do not
remove the wire tie yet.
4. Do not pinch the Upright Wire (not shown)
during this step.
Attach the Right Upright (73) to the Upright
Base (81) with two 3/8" x 2 3/8" Screws (4), a
3/8" x 1 3/4" Screw (33), and three 3/8" Star
Washers (5) as shown; do not fully tighten the
Screws yet.
See the inset drawing. Attach a Wheel (13) to
the Upright Base (81) with a 3/8" x 1 3/4" Screw
(33); do not fully tighten the Screw yet.
Attach the Left Upright (72) and the other
Wheel (not shown) in the same way.
See step 2. Remove the cardboard support (A)
and lower the Frame (48) to the floor.
3
C
73
74
81
4
72
81
13
33
9
C
D
74
73
81
4
5
5
33
73
4
5