3�9 INSTALLING THE OPTIONAL REMOTE CONTROLLER
This optional accessory replaces the integral controller
and can be installed up to10m away.
Take the lid off the IPT to gain access to the existing
controller. Remove the upper and lower front covers.
Disconnect the plug from the socket (inside sleeving)
on the back of the controller as shown.
Connect the lead. and slide the sleeving back over the
connectors. Secure the sleeving with a cable tie.
1007929 ISSUE 1
Feed the cable from the remote controller through the
upper cable access point.
Route the cable inside the IPT securing it where
necessary. Make sure there is a drip loop and that the
connector is above the lowest point in the cabling.
This hole.
19