Table of Contents
Advertisement
OWNER/INSTALLATION MANUAL
6�0 MAINTENANCE
Cover the heat pump body when not in use.
Please clean this machine with household detergents
or clean water, NEVER use petroleum spirit, thinners or
any similar fuel.
Check bolts, cables and connections regularly.
Regularly check condensate drain hose for blockages
and clear.
Keep evaporator clean and free from blockages with a
soft brush.To access the evaporator first isolate the heat
pump electrically using the mains isolator switch and
wait 3 minutes before removing any panels.
• Remove the screws at the bottom of the grilles
covering the evaporator, press the panels upwards
and pull away from the machine.
• Remove dirt and debris from the evaporator with a
soft brush [do not use excessive force as this may
damage the evaporator fins].
• Warning : Care must be taken not to touch the
evaporator fins with your hands as the edges are
sharp and may cause injury.
• Replace panels in reverse order, reconnect to the
electrical supply and switch the heat pump on.
Repair, service and disposal of redundant heat pumps
must be completed by authorised technicians. It is
illegal to allow refrigerant gases to escape to air.
34
Isolate the power
supply of the
heat pump and
wait 3 Minutes
before cleaning,
examination or
repair�
7�0 TROUBLE SHOOTING COMMON FAULTS
Do not attempt to work on the equipment by yourself.
Improper operation may cause danger.
Requirements for service personnel
Any person who is involved with working on or
breaking into a refrigerant circuit should hold a current
valid certificate from an industry-accredited assessment
authority, F-Gas registered.
Do not attempt to work on the equipment by
yourself�
1007929 ISSUE 1
Advertisement
Table of Contents
