DKN SMART POWER MACHINE Manual page 31

Note that the tightening torque used must comply with the reference values for
the specific type of screw. Otherwise the screws may be permanently damaged.
 R11 Display Motherboard
Repair Instructions
Use a screwdriver to remove the screws as shown. The figure above shows the
position of the screws of the Display Board. After unscrewing these screws, the
Display Board and the Display Module can be removed, and then the Display Board
can be removed by removing the clip connecting the board and the Display Module.
Before connecting to the Motherboard, you need to remove the Display FFC Cable
rom the Motherboard).
Note that the tightening torque used must comply with the reference values for
the specific type of screw. Otherwise the screws may be permanently damaged.
Please note that before removing The Motherboard, you need to unplug the
Sockets Connecting the WIFI and Bluetooth antennas to the Motherboard, otherwise
the WiFi and Bluetooth antennas will be permanently damaged.
31