Table of Contents
Advertisement
Disassembly of structural parts
IV.
1. Take out the Long Rod Bracket, the Screw positions are as follows;
Repair Instructions
Before removing the Long Pole Bracket, it is recommended to lay the machine
flat on the platform, and then use a screwdriver to unscrew the 4 screws shown in the
figure. The picture above shows the position of the screws of the Long Pole Bracket,
and different colors represent different screw types. After unscrewing these screws,
the Long Pole Brackets on both sides can be removed.
Note that the tightening torque used must comply with the reference values for
the specific type of screw. Otherwise the screws may be permanently damaged.
17
Advertisement
Table of Contents
