Table of Contents
Advertisement
7. Take out Motor Module and Electronic Control Module, the screw positions
are as follows;
Repair Instructions
Use a wrench to unscrew the nylon nut as shown. The picture above shows the
position of the screws of the Motor Module and Electronic Control Module. Different
colors represent different screw types. After unscrewing these screws, The Motor
Modules and Electronic Control Modules on both sides can be removed.
Note that the tightening torque used must comply with the reference values for
the specific type of screw. Otherwise the screws may be permanently damaged.
Please note that before removing the Motor Module and Electronic Control
Module, you need to unplug the wire connected to the Electronic Control Module
from the Electronic Control Board, otherwise the wire socket may be permanently
damaged.
23
Advertisement
Table of Contents
