DKN SMART POWER MACHINE Manual page 24

8. Take out the Motor Assembly, the screw positions are as follows;
Repair Instructions
Use a hex screwdriver to remove the screws as shown. The above picture shows
the position of the screws of the Motor Assembly, and different colors represent
different screw types. After unscrewing these screws, The Motor Assembly can be
removed.
Note that the tightening torque used must comply with the reference values for
the specific type of screw. Otherwise the screws may be permanently damaged.
Please note that before removing the Motor, you need to unplug the wire
connected to the Electronic Control Module from the Electronic Control Board,
otherwise the wire socket may be permanently damaged.
24