Adjusting The Bracket Position; Connecting The Hob To The Mains Power Supply - Scandomestic IKP 60 User Manual

Adjusting the bracket position

Fix the hob on the work surface by screw 4 brackets on the
bottom of hob (see picture) after installation.
Adjust the bracket position to suit for different table top
thickness.
HOB
BRACKET
A
Under any circumstances, the brackets cannot touch with the
inner surfaces of the worktop after installation (see picture).
Cautions
1. The induction hotplate must be installed by qualified personnel or technicians. We have professionals at your
service. Please never conduct the operation by yourself.
2. The hob will not be installed directly above a dishwasher, fridge, freezer, washing machine or clothes dryer, as
the humidity may damage the hob electronics
3. The induction hotplate shall be installed such that better heat radiation can be ensured to enhance its
reliability.
4. The wall and induced heating zone above the table surface shall withstand heat.
5. To avoid any damage, the sandwich layer and adhesive must be resistant to heat.
6. A steam cleaner is not to be used.

Connecting the hob to the mains power supply

This hob must be connected to the mains power supply only by a suitably qualified person
Before connecting the hob to the mains power supply, check that:
1. The domestic wiring system is suitable for the power drawn by the hob.
2. The voltage corresponds to the value given in the rating plate
3. The power supply cable sections can withstand the load specified on the rating plate.
To connect the hob to the mains power supply, do not use adapters, reducers, or branching devices, as they can
cause overheating and fire.
The power supply cable must not touch any hot parts and must be positioned so that its temperature will not
exceed 75°C at any point.
Check with an electrician whether the domestic wiring system is suitable without alterations.
Any alterations must only be made by a qualified electrician.
HOB
TABLE
BRACKET
B
TABLE
43