Scandomestic IKP 60 User Manual page 43

Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 5 cm space shall be preserved around the hole.
Be sure the thickness of the work surface is at least 30mm. Please select heat-resistant and insulated work surface material
(Wood and similar fibrous or hygroscopic material shall not be used as work surface material unless impregnated) to avoid the
electrical shock and larger deformation caused by the heat radiation from the hotplate. As shown below:
Note: The safety distance between the sides of the hob and
3mm.
L(mm) W(mm)
590 520
Under any circumstances, make sure the Induction cooker hob is well ventilated and the air inlet and outlet are not
blocked. Ensure the induction cooker hob is in good work state. As shown below
Note: The safety distance between the hotplate and the cupboard above the hotplate should be at least 760 mm.
A(mm) B(mm)
760 50 min.
WARNING: Ensuring Adequate Ventilation
H(mm) D(mm)
62 58
C(mm)
20 min.
the worktop should be at least
the inner surfaces of
A(mm) B(mm)
560+4 490+4
+1 +1
D
Air intake
41
X(mm) F(mm)
50 min. 3 min.
E
Air exit 5mm