Ginstalling A Lens/Connecting To A Video Monitor; Installing A Lens; Connecting To A Video Monitor - Toshiba IK-WB02A User Manual

Toshiba ik-wb02a: user guide
Hide thumbs Also See for IK-WB02A:
Table of Contents

Advertisement

Installing a Lens/Connecting to a Video Monitor

Installing a Lens

You can install a CS mount lens on the camera.
Important
When using a lens that weighs 400g or more including a zoom lens, make sure the lens
G
is supported as well as the camera in order not to cause damage due to overloading.

Connecting to a Video Monitor

You can view camera images on the video monitor. The camera also supports audio.
Connect an audio output
device to output the audio.
Connect a microphone
to input the audio.
IAbout Audio Input/Output
Use a microphone with plug-in power operation and a 3.5 mm monaural mini jack for
the AUDIO IN. Use a speaker with a built-in amplifier and a 3.5 mm monaural mini
jack for the AUDIO OUT.
Important
Power plugs of connected equipment must be disconnected before installation.
G
A 75-ohm coaxial cable (3C-2V or 5C-2V) is required for standard connection.
G
For details of wiring and operation of equipment to be connected, refer to their
G
operation manuals.
Lenses, coaxial cables for video signals, LAN cable and the power cord are not
G
supplied with the camera.
Do not connect AC24V and DC12V at the same time. It may cause a malfunction of
G
the camera or AC adapter.
Use a 4 pair twisted cable for the LAN cable to connect the camera to a PoE
G
compatible hub.
Use IEEE802.3af-compliant PoE devices.
G
An AC adapter is not supplied with the network camera. When using an AC adapter,
G
a 10 watt or greater AC adapter is required.
The camera takes about 30 seconds to start after the power is turned on.
G
8
Rear
AC24V
or DC12V
On the power supply, use a PoE compatible hub, or connect
7
AC24V or DC12V power plug.
If power is to be supplied from a PoE compatible hub, etc., switch the
7
POWER SELECT switch to PoE.
If an AC24V or DC12V power supply is to be connected, switch the
7
POWER SELECT switch to AC24V/DC12V.
Video Monitor
LAN cable
PoE (IEEE802.3af)
compatible hub, etc.
Either

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents