Toshiba IK-WB02A User Manual page 56

Recording Images on an SD Memory Card (Cont.)
Configure each setting items.
IAlarm Recording
GExternal Alarm
ON: To record images when an external alarm occurs.
OFF: Does not to record images when an external alarm occurs.
GMotion Detection
ON: To record images when a motion is detected
OFF: Not to record images when a motion is detected
GPre-Recording
Pre-Recording records image(s) of right before alarm was generated.
You can set numbers of frames you want to record. The image at the moment the
alarm was generated will not be included.
GPost-Recording
The Post-Recording records image (s) at the moment and after an alarm was
generated.
You can set numbers of frames you want to record.
GInterval(s)
Configures recording cycle of Pro-Recording and Post Recording.
INormal
ON: To record images depending on the recording intervals and timer association
OFF: Not to operate normal recording
GInterval(s)
Configure recording cycle of Normal Recording images.
GTimer Association
ON: To turn on the timer association
OFF: To turn off the timer association
When "Timer Association" is set to "ON," configure the start/stop time for
recording.
GOverwrite
ON: To overwrite data in the order of the oldest to the newest when the SD
OFF: To stop recording when the SD memory card becomes full during record-
To finish configuring Recording Settings, click the "Save"
button below the setting.
The changes are saved.
G
NOTE
• Total number of recorded image frames per one alarm will be the sum of Pre-Recording
image(s) + Post-Recording image(s).
• To configure the external alarm/motion detection, select "ON" in "External Alarm Detect"
or select "Enable" in "Motion Detect" in the alarm settings (➝ page. 64).
40
memory card becomes full during recording.
ing.