Installation -
Installation
1. Attach the camera base to the mounting surface using the
included anchors and screws.
2. To use the wiring pipe hole
(optional) on the top or bottom
of the camera, use metal clips to
cut the two small metal inserts and
remove the middle knockout plug.
3. Pass a 1/2" NTP pipe through the
newly made wiring hole and secure
the pipe to the mounting surface.
4. The camera motherboard can be
mounted on three locations on the
camera based, depending on the
desired height of the camera. Once
you have chosen the lens height
from the options (
,
a
secure the camera motherboard
to the camera base by tightening
the two (2) screws at the top and
bottom of the motherboard. Use a .
5. Using the lens blocks included,
cover the two remaining lens
11 1
, or
),
b
c
9
a
b
c