Digital Watchdog MEGApix DWC-MHS5W37T User Manual page 3

Important Safety Instructions
1. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point
where they exit from the product.
2. If any laser equipment is used near the product, make sure the surface of the sensor is not exposed to
the laser beam as that may damage the sensor module.
3. If you want to move the already installed product, be sure to turn off the power and then move or
reinstall it.
4. Proper configuration of all passwords and other security settings is the responsibility of the installer
and/or end-user.
5. If cleaning is necessary, please use a clean cloth to wipe it gently. If the device will not be used for a
long time, please cover the lens cap to protect the device from dirt.
6. Do not touch the camera's lens or sensor module with your fingers. If cleaning is necessary, please use
a clean cloth to wipe it gently. If the device will not be used for a long time, please cover the lens cap to protect the device
from dirt.
7. Use only attachments/accessories specified by the manufacturer.
8. Always use hardware (e.g. screws, anchors, bolts, locking nuts, etc.) compatible with the mounting surface and of sufficient
length and construction to ensure a secure mount.
9. Use only with cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the product.
10. Unplug this product when a cart is used. Use caution when moving the cart/product combination to avoid injury from tip-
over.
11. Refer all servicing to qualified service personnel. Servicing is needed when the product has been damaged in any way, such
as a power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the product, the product has
been exposed to rain or moisture, does not operate normally, or has been dropped.
Copyright © Digital Watchdog 2023. All rights reserved. Specifications and pricing are subject to change without notice.
Legal considerations
Video surveillance can be regulated by laws that vary by region. Check the laws in your local region before using this product
for surveillance purposes.
Liability
Regarding the preparation of this document, Digital Watchdog cannot be held responsible for any technical or typographical
errors and reserves the right to make changes to the product and manuals without notice.
Digital Watchdog makes no warranty of any kind regarding the written material contained within this document. Digital
Watchdog shall not be held liable nor responsible for any incidental or consequential damages in connection with the
furnishing, performance, or use of this documented material. This product is only to be used for its intended purpose.
Equipment modifications
This equipment must be installed and used in strict accordance with the instructions given in the user documentation. Changes
or modifications not expressly approved by the party responsible for compliance could void the user's authority to use the
equipment.
Trademark acknowledgments
Digital Watchdog, DW, DW Spectrum, MEGApix and Star-Light are registered trademarks or trademark applications of Digital
Watchdog in various jurisdictions.
microSD, microSDHC, and microSDXC Logos are trademarks of SD-3C LLC. microSD, microSDHC and
microSDXC are trademarks or registered trademarks of SD-3C, LLC in the United States, other countries, or both.
Regulatory Information
USA
This device complies with part 15 of the FCC Rules, subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, according to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used following the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help
3