Attaching The Embroidery Frame To The Machine - Brother 882-T52 Operation Manual

Attaching the embroidery frame to the machine

• If the embroidery frame is not correctly attached, it may hit the presser foot and damage the machine, or
cause injury to the user.
• When attaching the embroidery frame, make sure that the "Start/Stop" button is lit in red. If the "Start/
Stop" button is flashing in green, the machine may start embroidering. If the machine accidentally starts
operating, injuries may result.
a
1 Left arm
2 Thumb screws
• Loosen the two thumb screws on the Embroidery
Frame Holder.
Note
• Please firmly tighten the two thumb screws with included 3-way screwdriver. If the thumb screws are not tightened,
any of the following problems may occur.
- The machine will detect the embroidery frame size incorrectly.
- The starting position for the embroidery frame is misaligned.
- The embroidery pattern is misaligned.
CAUTION
1 Left arm of Embroidery Frame Holder
Move the arm of the Embroidery Frame Holder to the left or
right to adjust it to the size of the embroidery frame.
2 Clip on Embroidery Frame Holder
Insert the embroidery frame into the clips on the Embroidery
Frame Holder.
3 Positioning pin
4 Holes
5 Positioning slots
b
1 Mark for extra-large embroidery frame
2 Mark for large embroidery frame
3 Mark for medium embroidery frame
4 Mark for small embroidery frame
5 Align the screw with the mark.
27