Attaching The Embroidery Frame To The Machine - Brother 882-T51 Operation Manual

Attaching the embroidery frame to the machine

• If the embroidery frame is not correctly attached, it may hit the presser foot and damage the machine, or
cause injury to the user.
• When attaching the embroidery frame, make sure that the "Start/Stop" button is lit in red. If the "Start/
Stop" button is flashing in green, the embroidery machine may start embroidering. If the embroidery
machine accidentally starts operating, injuries may result.
• When attaching the embroidery frame, make sure that the embroidery frame does not hit any other part of
the embroidery machine.
a
1 Left arm
2 Thumb screws
Loosen the two thumb screws on the embroidery
frame holder.
24
CAUTION
1 Left arm of embroidery frame holder
Move the arm of the embroidery frame holder to the left or right
to adjust it to the size of the embroidery frame.
2 Clip on embroidery frame holder
Insert the embroidery frame into the clips on the embroidery
frame holder.
3 Positioning pin
4 Holes
5 Positioning slots
b
1 Mark for extra-large embroidery frame
2 Mark for large embroidery frame
3 Mark for medium embroidery frame
4 Mark for small embroidery frame
5 Align the screw with the mark.