Replacing The Needle - Brother 882-T52 Operation Manual

Replacing the needle

• Be sure to turn off the machine before replacing the needle, otherwise injuries may result if the machine
starts embroidering.
• Never use bent needles. Injuries may result.
• Be sure to insert the needle in the needle bar chamber until it reaches the needle bar stopper and securely
tighten the needle set screw with the Allen screwdriver, otherwise the needle may break and cause injury.
Memo
• Your machine is designed to use household embroidery needles. The factory recommended needle is "HAX 130
EBBR" (Organ). Schmetz needles 130/705 H-E may be used as a substitute.
• To check the needle correctly, place the flat side of the needle on a flat surface. Check the needle from the top and
the sides. Throw away any bent needles.
a
c
1 Needle bar stopper
2 Needle
3 Flat side of needle
4 Needle changing tool
34
CAUTION
1 Parallel space
2 Flat surface (glass, etc.)
b
1 Allen screwdriver
Memo
1 End of the needle changing tool
2 Needle mounting clamp
• Hold the needle changing tool and press the end of the
needle changing tool 1 in to extend the
needlemounting clamp 2. Attach the clamp to the
needle, and then release the pressed area to clamp the
needle. To unclamp the needle, press 1 again.
a