Operating Controls On The Tv Set - Loewe Reference 85 User Manual

Reference 55-85
User manual

Operating controls on the TV set

Functions of the operating elements
5
9
-
3
(1 Automatic dimming depending on the room brightness (OPC) must be activated (see chapter System settings, section Picture).
6
M
4
1
8
+
2
R
7
1
Mains switch:
The mains switch is located on the bottom of the set.
Always return the TV set to Standby mode before switching it off
with the main switch.
2
On/Off key:
Switching on in standby mode.
Switching off to the standby mode.
3
IR receiver:
Infrared receiver for receiving the remote control commands.
4
Display:
white: TV set in standby.
Depending on the ambient brightness, the
white LED display is dimmed
up with a different degree of brightness.
If the TV set is in quick start mode, the
white LED display is not dimmable and
starts with full brightness.
white, intermittent: TV set starts.
green: TV set switched on.
red: timer recording active.
blue: TV set in standby and background operation
active (EPG data updating, software update
or DR+ streaming server function).
5
Infrared transmitter:
When showing 3D content, the 3D glasses Loewe Active
Glasses 3D are controlled via the infrared sensor.
6
Key M:
TV set in standby mode: switch TV set on in TV mode.
TV set switched on: call direct control on TV set.
In direct control on TV set: up
7
Key R:
TV set in standby mode: switch TV set on in radio mode.
TV set switched on: toggle TV mode and radio mode.
Direct control on TV set: down
8
Key +:
TV set in standby mode: switch TV set on in TV mode.
Increase volume.
Direct control on TV set: to the right
9
Key – :
TV set in standby mode: switch TV set on in TV mode.
Reduce volume.
Direct control on TV set: to the left
(1 and lights
.
.
.
.
9