Automatic Scan Tv+Radio - Loewe Reference 85 User Manual

Reference 55-85
User manual
System settings
Stations

Automatic scan TV+Radio

For automatic scan TV+Radio, a search wizard will be started that
searches for new stations which are not yet stored.
You have to repeat the initial installation and
automatically search for new stations if you want to
delete all the existing stations and automatically
search for new ones.
HOME: Call Home view.
Mark System settings,
OK call System settings.
Mark Stations,
go to next column.
Mark Automatic scan TV+Radio,
go to next column.
In the upper info text the current search settings will
now be displayed:
SEARCH WIZARD - Check search settings
Your TV carries out the update of the station list (search for new stations; delete
... ...
stations no longer broadcast) with the following settings:
Location of TV set
Signal source
Change search settings
End with
If you want to change these search settings:
Select Change search settings,
OK wizard guides you through the search settings
(see column on the right).
If you agree with these settings:
Select Start search/update,
OK start scan.
BACK: Cancel current search/update.
Explanations of some search settings:
Signal source Select cable (analogue), DVB-T, DVB-C or DVB-S
depending on which signal source you want to search
for new stations.
Use the Antenna wizard to call the configuration of
the DVB-T and DVB-S antennas.
Calling up the DVB antenna configuration causes
the Change search settings dialogue to be quit.
You must call up the dialogue again after finishing
the configuration.
Cable With the selection of TV set location the conventional
(analogue) TV standard/colour standard is the default.
TV/colour It should only be changed if stations with other
standard standards are to be searched.
D Germany
Cable analogue
Start search/update
Explanations of some search settings (continued):
DVB-T/C/S If several networks are available, you can decide
Network which network you want to receive your channels
selection from.
DVB-T/C/S With the selection of set location the conventional
Settings settings will be preset. Only change these defaults
if you are familiar with other parameters.
Scrambled stations: (DVB-T/C/S)
You can state whether scrambled stations are to be
searched for in the search/update. If you select yes,
coded stations will also be searched for. However,
these stations can only be received in connection
with a CA module and the appropriate Smart Card.
Ask your dealer which Smart Card you need to
receive certain stations.
Search method: (DVB-T)
If you want to run the station search independently
of the channel grid, select Frequency search for
the search method.
Search method: (DVB-C)
If you select Frequency search here, a search is
performed for all receivable stations. With Network
search, only the stations which the networks sup-
ply are searched - either for all receivable networks
or only for the particular network specified under
Network ID.
Network ID: (DVB-C)
If you select none here, DVB signals of all current
broadcasting networks are scanned automatically
(recommended for most cable networks).
If, on the other hand, you specify a certain network ID
(necessary in the cable networks of some countries),
only DVB signals of this broadcasting network are
searched for automatically. Your cable provider has
the information you need.
Search method: (DVB-S)
If you select Frequency search here, a search is
performed for all receivable stations. With Network
search, from all receivable networks all the stations
are searched which are supplied by these networks.
Accept Logical Channel Number: (DVB-T/C/S)
In various countries, digital stations (DVB-T/C/S) are
transmitted with a preset channel number per
station, known as Logical Channel Numbers (LCN).
If you select yes here, these default channel slots
will be used and the channels of the preferred signal
source will be sorted as per LCN. The stations in the
station list can no longer be shifted.
81