Table of Contents
Advertisement
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
b
Turn the presser foot pressure dial at the back
of the machine to adjust the pressure of the
presser foot.
The scale on the dial indicates the range from
1 (weak) to 4 (strong). Turn the dial to the right
(smaller number) to decrease the pressure.
Turn the dial to the left (larger number) to
increase the pressure.
a Strong
b Weak
c
When you are finished sewing, reset the dial to
3 (standard).
Sewing thick fabrics
■ If the fabric does not fit under the presser foot
If the fabric does not fit easily under the presser
foot, raise the presser foot lever even higher to
bring the presser foot to its highest position.
■ If thick seams are being sewn and the fabric does
not feed at the beginning of stitching
The fabric may not feed when thick seams are
being sewn and the presser foot is not level, as
shown below. In this case, use the presser foot
locking pin (black button on the left side of zigzag
foot "J") so that the presser foot remains level
while sewing, allowing the fabric to be fed
smoothly.
a Sewing direction
a
b
c
d
● If fabric more than 6 mm (15/64 inch)
a
Raise the presser foot lever.
Align the beginning of stitching, and then
position the fabric.
While holding zigzag foot "J" level, hold the
presser foot locking pin (black button on the
left side) pressed in, and lower the presser foot
lever.
1
a Presser foot holding pin (black button)
Release the presser foot locking pin (black
button).
The presser foot remains level, allowing the
fabric to be fed.
After the seam is sewn, the presser foot will
return to its original angle.
CAUTION
thick is sewn or if the fabric is pushed with
too much force, the needle may bend or
break.
Useful Sewing Tips 65
2
Advertisement
Table of Contents
