Assa Abloy Corbin Russwin SN Series Installation Instructions Manual page 13

SN200/210 Integrated Wired
With and Without MELR Option (Electric Latch Retraction)
3 Install Outside Trim and Inside Trim
A. Outside Trim
1. For exterior applications, use ET gasket to seal ET
escutcheon and outside door surface (Fig. 3a).
2. Feed wire through the through hole and attach the outside exit
trim to the door.
B. Inside Trim
1. Position ET carefully onto the inside door surface
the inside of the door. Be careful not to pinch wire harness.
2. Mount inside trim lever using (2) # 1/4" -20 x 3" Philips oval head
machine screws. (Fig. 3b).
4 Install Reader Backplate and (Optional*) Fire Shield
For fire-rated doors only, install reader backplate and fire shield to door using two (2) #8-18 x 5/8"
Phillips flat head self-drilling screws (Fig. 4a, b).
Reader
Backplate
Copyright © 2020-2023 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights
reserved. Reproduction in whole or in part without the express written permission of
ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Fig. 4a
Outside Face
of Door
(2) #8 x 5/8" Phillips flat
head self-drilling screws
13
Fig. 3a
Fig. 3b
Fig. 4b