Flush Mount Side Trim Installation - Viking FDSB5423 Installation Manual

Flush Mount Side Trim Installation

Headline
(Sold Separately)
Note: If the unit is to be installed fl ush with the
cabinets, the fl ush mount side trim must be
installed fi rst. If not, skip to "Installation".
Step 1 - Locate the necessary parts: Two (2)
fl ush mount trim pieces and a hardware kit with
twenty-two (22) screws.
Step 2 - Remove the side trim on the refrigerator
and discard the trim and screws.
Installation
1
Place unit in front of cutout.
3
Using an 8" (20.3 cm) magnetic nut driver, remove
the two 1/4" (0.6 cm) screws.
Step 3 - Align the top of the fl ush mount
side trim with the top of the unit's machine
compartment. Using the screws included in the
hardware kit, attach the side trim to the unit,
only using the holes visible through the side
trim. Note: DO NOT use the screw holes in the
machine compartment.
2
Pull the center grille louver up at an angle and pull out.
4
Remove grille assembly.
24 24