Side By Side Installation - Viking VURE524G Install, Use, & Care Manual

Installation
Side-by-Side Installation
OTHER SITE REQUIREMENTS
Side-by-Side Installation
Units must operate from separate, properly grounded electrical
receptacles placed according to each unit's electrical specifi cations
requirements.
Cutout width for a side-by-side installation is the total of the widths
listed under Cutout Dimensions in each unit's Installation Guide.
Each door can be opened individually (one at a time) without
interference.
However, to ensure unobstructed door swing (opening both doors
at the same time), 1/4" (6.4 mm) of space needs to be maintained
between the units.
1 / " (6 mm)
4
Hinge-by-Hinge Installation (Mullion)
When installing two units hinge-by-hinge, 13/16" (22 mm) is
required for integrated models. Additional space may be needed for
any knobs, pulls or handles installed.
Stainless steel models which include the standard stainless handle
will require 4-9/16" (116 mm) to allow both doors to open to 90° at
the same time.
5
/ " (22 mm)
13
16
4 - / " (116 mm)
9
16