Miller Maxstar 300 DX Owner's Manual page 33

4-7. Process Control
4-8. Output Control
1 Output Control
Press switch pad until desired param-
eter LED is illuminated.
RMT STD (Remote Standard)
Application: Use Remote Trigger
(Standard) when the operator desires
to use a foot pedal or finger amperage
control (see Section 4-19A).
NOTE: When a foot or finger remote
current control is connected to the
welding power source, initial amps,
initial slope, final slope, and final amps
1
1
are controlled at the remote control,
not at the welding power source.
NOTE: If On/Off only type trigger is
used, it must be a maintained switch.
All Sequencer functions become ac-
tive, and must be set by the operator.
RMT 2T HOLD
Application: Use Remote Trigger
Hold (2T) when long extended welds
are made. Remote Trigger Hold (2T)
can help to reduce operator fatigue.
If a foot or finger current control is con-
nected to the welding power source,
1 Process Control
Press switch pad until desired pro-
cess LED is illuminated:
TIG HF Impulse - When selected,
a pulsed HF (non-contact) (see
Section 9-3) arc starting method is
activated. This method can be used
with either AC or DC TIG welding.
Make connections according to
Section 3-11.
TIG Lift-Arct - When selected, is
an arc starting method in which the
electrode must come in contact
with the workpiece to initiate an arc
(see Section 9-3). This method can
be used with either AC or DC TIG
welding. Make connections ac-
cording to Section 3-11.
Stick (SMAW) - This method can
be used with either AC or DC Stick
welding. Make connections ac-
cording to Section 3-12.
only trigger input is functional (see
Section 4-19B).
NOTE: This switch function can be re-
configured for 4T, 4T Momentary, Mini
Logic, or Spot control See Section
4-19C)
ON
Output will energize two seconds after
being selected.
Application: Use Output On for Stick
(SMAW) welding, or for Lift-Arc with-
out the use of a remote control (see
Section 4-19H).
OM-2222 Page 27