The rectangular section of the clips is aligned in the lon-
gitudinal direction of the car.
5. To remove a clip: Insert a flat object, such as
a table knife or a screwdriver, on the short
sides of the clip so that both of the clip's
lock lugs are pressed in simultaneously and
then prize/pull out the clip.
The hinge's plastic guard is fitted with a plastic rivet and
three latches.
6. To remove the hinge's plastic guard on the
side where the lamp is fitted: Press in the pin
in the centre of the plastic rivet using a
screwdriver or similar: Then pull/prize out the
plastic rivet.
7. After that, open the plastic guard's three
latches using a small screwdriver, for exam-
ple, and place the plastic guard to one side.
MAINTENANCE AND SERVICE
8. Carefully pull/fold down the detached part of
the panel in order to access the bulb.
NOTE
Points to remember when the plastic rivet for
the hinge's plastic guard is refitted:
Before you can use the plastic rivet for
•
refitting, you must first press its centre pin
backwards as far as it protrudes from the
plastic rivet.
When the hinge's plastic guard has been
•
fixed in place, press the plastic rivet into
the hole in the plastic guard.
Finally, press the pin into the plastic rivet
•
until the end surface is level with the sur-
face of the plastic rivet.
}}
587