Volvo S90 Owner's Manual page 549

WARNING
Please keep the following points in mind
when using the tyre sealing system:
The sealing fluid bottle contains 1) rubber
•
latex, natural and 2) ethanediol. These
substances are harmful if swallowed.
The contents of this bottle may cause
•
allergic skin reactions or otherwise be
potentially harmful to the respiratory tract,
the skin, the central nervous system, and
the eyes.
Precautions:
Store out of the reach of children.
•
Harmful if ingested.
•
Avoid prolonged or repeated contact with
•
the skin. If sealing fluid has come into
contact with your clothes, remove them.
Wash thoroughly after handling.
•
First aid:
Skin: Wash affected areas of skin with
•
soap and water. Get medical attention if
symptoms occur.
Eyes: Flush with plenty of water for least
•
15 minutes, occasionally lifting the upper
and lower eyelids. Get medical attention if
symptoms occur.
An authorised Volvo workshop is recommended.
8
Inhalation: Move the exposed person to
•
fresh air. If irritation persists, get medical
attention.
Ingestion: Do NOT induce vomiting
•
unless directed to do so by medical per-
sonnel. Get medical attention.
Disposal: Dispose of this material and its
•
container at a hazardous or special waste
collection point.
WARNING
Do not remove the bottle when the punc-
•
ture repair kit is being used.
Do not remove the air hose when the
•
puncture repair kit is being used.
1. Set up the warning triangle and activate the
hazard warning lights if a tyre is being sealed
in a trafficked location.
If the puncture was caused by a nail or simi-
lar, allow this to remain in the tyre. It helps to
seal the hole.
WHEELS AND TYRES
2. Detach the decal for maximum permitted
speed that is affixed on one side of the com-
pressor. Affix it visibly on the windscreen as a
reminder to observe the speed limit. You
should not drive faster than 80 km/h
(50 mph) after the emergency tyre repair kit
has been used.
3. Check that the switch is in position 0 (Off),
and locate the electrical cable and the air
hose.
4. Unscrew the orange-coloured cap from the
compressor, and unscrew the cork from the
sealing fluid bottle.
5. Screw in the bottle to the bottom of the bot-
tle holder.
The bottle and the bottle holder are equip-
ped with a reverse catch to prevent sealant
leakage. When the bottle is screwed in it
cannot be unscrewed from the bottle holder
again. The bottle must be removed at a work-
8
shop .
WARNING
Do not unscrew the bottle, it is equipped with
a reverse catch to prevent leakage.
}}
547