Volvo S90 Owner's Manual page 582

MAINTENANCE AND SERVICE
Bulb replacement
Lamp types vary depending on model and
14
equipment level. If a bulb
replaced according to the method described in
the Owner's Manual.
15
Contact a workshop if faults occur in lamps
other than bulbs.
16
If a fault occurs in LED lamps, the entire lamp
unit usually must be replaced.
NOTE
For information about bulbs not covered in
this Owner's Manual, contact a Volvo dealer
or a certified Volvo service technician.
WARNING
The car's electrical system must be in ignition
position 0 when replacing bulbs.
IMPORTANT
Never touch the glass part of the bulbs with
your fingers. Grease from your fingers is
vaporised by the heat, coating the reflector
and then causing damage.
14 Some cars have no bulbs.
15 An authorised Volvo workshop is recommended.
LED (Light Emitting Diode)
16
580
If an error message remains after the broken
breaks, it can be
bulb has been replaced then we recommend
visiting an authorised Volvo workshop.
Outside lighting such as headlamps and rear
lamps may temporarily have condensation on
the inside of the lens. This is normal, all exte-
rior lighting is designed to withstand this.
Condensation is normally vented out of the
lamp housing when the lamp has been
switched on for a time.
Related information
Exterior lamp positions (p. 581)
•
Removing the plastic cover for bulb replace-
•
ment (p. 581)
Replacing the dipped beam bulb (p. 582)
•
Replacing the main beam lamp (p. 583)
•
Replacing daytime running light bulb/posi-
•
tion lamp bulb, front (p. 584)
Replacing the front direction indicator bulb
•
(p. 585)
Replacing the rear fog lamp bulb (p. 585)
•
NOTE
NOTE
Bulb specifications (p. 589)
•