Volvo S90 Owner's Manual page 467

Programming HomeLink
Follow these instructions to program
®
HomeLink , reset all programming or reprogram
individual buttons.
NOTE
In certain vehicles the ignition must be
switched on or in "accessory position" before
®
HomeLink can be programmed or used. If
possible, fit new batteries in the remote con-
trol that shall be replaced by HomeLink
faster programming and improved transmis-
sion of the radio signal. The HomeLink
tons should be reset before programming.
WARNING
®
While programming HomeLink
door or gate being programmed may activate.
For this reason, make sure that nobody is in
the vicinity of the door or gate while program-
ming is in progress. The car should be outside
the garage while a garage door opener is
being programmed.
Applies to certain markets.
30
®
30
1. Aim the remote control towards the
*
HomeLink
hold it approx. 2-8 cm (approx. 1-3 inches)
from the button. Do not obstruct the indicator
lamp on HomeLink
Note: The ability of some remote controls to
program HomeLink
tance of approx. 15-20 cm (approx. 6-12
inches). Bear this in mind if problems occur
with the programming.
®
for
2. Press and hold depressed both the button
on the remote control and the button to be
®
but-
reprogrammed on HomeLink
, the garage
®
button to be programmed and
®
.
®
is improved at a dis-
®
.
STARTING AND DRIVING
3. Do not release the buttons until the indicator
lamp has switched from flashing slowly
(approx. once per second) to either flashing
quickly (approx. 10 times per second) or illu-
minating with a constant glow.
> If the indicator lamp illuminates with a
constant glow: Indication that the pro-
gramming has finished. Press the pro-
grammed button twice to activate.
If the indicator lamp flashes quickly:
The device to be programmed to
®
HomeLink may have a security function
that requires extra steps. Test by pressing
the programmed button twice to see
whether the programming is working. Oth-
erwise, continue with the following steps.
}}
465
* Option/accessory.