Dmx-Protocol - EuroLite LED Z-PAR QCL 7X10W User Manual

If several devices are addressed similarly, they will work synchronically.
Press the Up/Down-buttons for setting the desired starting address. Now you can start operating the device
via your lighting controller.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If the data
is received, the display will show "A001" with the actually set address. If there is no data received at the
DMX-input, the display will show "d001" with the actually set address.
This situation can occur if:
- the XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.

DMX-protocol

Decimal Hexad. Percentage S/F
0 255 00 FF 0% 100%
Decimal Hexad. Percentage S/F
0 255 00 FF 0% 100%
Decimal Hexad. Percentage S/F
0 255 00 FF 0% 100%
Decimal Hexad. Percentage S/F
0 255 00 FF 0% 100%
Decimal Hexad. Percentage S/F
0 255 00 FF 0% 100%
Decimal Hexad. Percentage S/F
0 255 00 FF 0% 100%
Decimal Hexad. Percentage S/F
0 255 00 FF 0% 100%
Decimal Hexad. Percentage S/F
0 255 00 FF 0% 100%
Control-channel 1 - Stepless Zoom
F Zoom adjustment from small to big
Control-channel 2 - Dimmer intensity
F Gradual adjustment of the dimmer intensity from 0 to 100 %
Control-channel 3 - Strobe
F Strobe-effect with increasing speed
Control-channel 4 - Red
S Red (0=off, 255=100% red)
Control-channel 5 - Green
S Green (0=off, 255=100% green)
Control-channel 6 - Blue
S Blue (0=off, 255=100% blue)
Control-channel 7 - White
S White (0=off, 255=100% white)
Control-channel 8 - Color presets
F Color presets
24/26
Feature
Feature
Feature
Feature
Feature
Feature
Feature
Feature
00091873, Version 1.0