Operation; Stand-Alone Operation; Master/Slave Operation - EuroLite LED Z-PAR QCL 7X10W User Manual

The device is equipped with a lockable power input connector. Plug in the power cord and turn it to the right
until it locks. Plug the power cord into a grounded electrical outlet that matches the rated voltage of the
machine.

OPERATION

After you connected the spot to the mains, the device starts running.
The LED display lights up and you can choose the desired mode via the buttons MENU, UP, DOWN and
ENTER.

Stand-alone operation

In the Stand-alone mode, the device can be used without controller.
Disconnect the device from the controller and call the internal program. Please refer to the instructions under
Control Board.

Master/Slave operation

The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the device you can find an XLR jack and an XLR plug, which can be used for
connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX-cable. Connect the OUT jack
with the IN plug of the next device.
Set the desired Master-mode - „Auto" or „AudI" - for the master-device. Set the DMX address 001 for all
slave-devices. Please refer to the instructions under chapter operation.
22/26 00091873, Version 1.0