Table of Contents
Advertisement
a. Open the retention clip and slide it away from the connectors.
b. Gently pull up the top corner of the cable latch door.
c. Disconnect the card cables.
9.
Remove the adapter (Removing and replacing an expansion board).
10. Disconnect the cables to the adapter.
To replace the component:
1.
Thread the adapter end of the auxiliary card cables through one of the retention clips provided with the installation kit.
2.
Open the cable latch door, connect the auxiliary card cables to the adapter ports so that the golden side of the cable
connector is on the top, and then close the cable latch door.
The white and black cables from the auxiliary card connect to the expansion board ports labeled WHITE CABLE and
BLACK CABLE, respectively.
The cable latch door must be open when connecting the cables.
CAUTION: The connector pins are fragile and easily damaged. To avoid damaging the connector pins, do not use
excessive force when connecting the cables.
74
Removal and replacement procedures
Advertisement
Table of Contents
