Programming Operator And Accessories: Introduction - Genie GCL-LJ Series Manual

PROGRAMMING OPERATOR & ACCESSORIES
4
NOTE: Before programming the operator, check to make sure there are no objects in the garage door opening. DO NOT allow persons to
enter the area of the door while programming and operating.
The following steps list the order of programming the operator's functional settings as well as installation of any accessories that
were included with the operator or purchased separately. These steps should be performed in order.
1. Adjust operator speed for drum sizes
2. Down travel limit
3. Up travel limit
4. Force control
5. Contact reverse test and adjustment
6. Remote control programming
7. Light fixture programming (if applicable)
8. Wireless wall console programming (if applicable)
9. Program wireless keypad (if applicable)
10. Program built in vehicle remote (if applicable)
11. Program the integrated Wi-Fi Genie Aladdin Connect® (if applicable)
NOTE: When operator is activated to close, operator will start and stop slowly in small increments making a pulsing sound to detect cable
tension then run at normal speed to close. This is normal operation and is called Safe-T-Pulse™.
NOTE: Each programming step has a 30 second time limit for completion after the function is initiated. After 30 seconds, both LEDs will illuminate BLUE indicating time has
expired and the step must be restarted. Restart the step as many times as necessary to complete the programming.
Remote controls, wireless keypads, wireless wall controls and bluetooth control programming will reset after 60 seconds.
24
Programming Button Layout
Wi-Fi Program
Program/Set
Long LED
Indicator
Round LED
Indicator
Wi-Fi LED
Close Travel
Button
Open Travel
Button