Install And Wire Door Lock (Optional) - Genie GCL-LJ Series Manual

Install Door Lock - (Optional)
Door lock prevents manual door operation and is important for garage security.
NOTE: Door lock should be installed no more than 10' away on the operator side of the door if possible.
1. Mount door lock onto door track above a roller on the second or third door panel from the floor.
If mounting position does not line up with pre-punched door lock bar cutouts as shown below:
• Remove template from the back page of the owners manual.
• Apply door lock drilling template to the door track where the center 7/16" hole is approximately 3 inches above the door roller
on the 2nd or 3rd door panel.
• Drill two 9/32" holes for mounting and one 7/16" hole if using template. De-burr holes if required.
2. Position door lock and install two 1/4" X 9/16" track bolts and nuts. Install track bolt on inside of door track facing outward.
18
WIRE THE OPERATOR
Approx. 3"
9/32"
7/16"
Bit
7/16"