Operator Cycle Count
1) Press CAL/RUN
CAL
key to enter calibration mode.
RUN
2) Press SCROLL
key until display reads "CYCLES>1,2,3 etc.
SCROLL
where the number is the number of open/close cycles the operator
SC OL
has performed. Figure 1.
R
3) Press CAL/RUN
CAL
key to return to run mode.
RUN
GDO and Display Firmware
1) Press CAL/RUN
CAL
key to enter calibration mode.
RUN
2) Press SCROLL
key until display reads "GDO V# > ######." Figure 2
SCROLL
RO
This display will cycle between the version number of the current GDO
firmware and the current Display Firmware.
SE
C AR
OLL
3) Press CAL/RUN
key to return to run mode.
CAL
RUN
Section 7: Special Operator Features
E
www.geniecompany.com
.
(No user input)
OPEN
CYCLES 1
CLOSE
Figure 1
OPEN
GDO V# #########
CLOSE
OPEN
DISPLAY V# #######
CLOSE
Figure 2
01-14
STOP
STOP
STOP
7.1