Trigger; Trigger Signal Processing Procedure - Omron STC-MBS642POE Product Specifications And User's Manual

10.11

Trigger

The trigger type (trigger source) is selectable at "TriggerSource" under "AcquisitionControl".
The trigger type (trigger source) is listed in below table.
Software
Software Signal 0
Software Signal 1
Action 0
Line 0
Line 2
Logic Block 0

Trigger signal processing procedure

The camera internal process for external hardware trigger signal or software trigger signal input is below:
Line 0
Debounce
Line 2
Debounce
Software Signal 0
Software Signal 1
The trigger signal is selectable by GenICam commands.
TriggerSource: select trigger type
STC-MBS642POE / STC-MCS642POE
Product Specifications and User's Guide
Software trigger generates by "TriggerSoftware"
Software trigger generates by "SoftwareSignalControl"
Software trigger generates by "SoftwareSignalControl"
Action command trigger
Hardware trigger through "Line0"
Hardware trigger through "Line2"
Trigger generates by "LogicBlockControl"
Please refers "Trigger signal processing procedure" for more details
Line 0
Line 2
Software
Action 0
Logic Block 0
" AND "
or
" OR "
Trigger Delay
Trigger
Source
No.19S210-01
Camera
Timing
Generator
Sensor
48/69