i-PRO WV-U85402-V2L User Manual page 389

4 Advanced settings
4.11 Networking configuration [Network]
[Camera short cut]
Use the [On] and [Off] buttons to specify whether to make shortcuts to the cameras in the
[Network] folder of your computer.
Select [On] to shortcut the cameras.
To use the camera shortcut function, enable the UPnP function on the PC beforehand.
4.11.2.5 Set up HTTPS
By using the HTTPS function, you can encrypt the access to the camera and increase the security
of communication.
For details on how to configure HTTPS, see below.
→4.11.3 Setting up HTTPS
[Note:]
・Automatic port forwarding may change the port number. If this is changed, the
port number of the camera registered on the PC or recorder must be changed.
・The UPnP feature can be used to connect a camera to an IPv4 network. IPv6 is
not supported.
・To verify that auto-port forwarding has been configured correctly, click on the
[Status] tab on the Maintenance page and make sure that the [UPnP] status is
[On].
→4.13.3 [Status] for checking the status
If [On] is not displayed, please read [Cannot access cameras from internet] in
"Trouble!?"
→5.2 Trouble!?
・If the live screen or configuration screen is not displayed correctly, such as when
replacing the routers to be used, set [UPnP(Auto port forwarding)] to [Off] once
and then set it to [On] again.
[Note:]
・You must add a Windows component to view shortcuts to the cameras in the
Windows [Network] folder. Enable UPnP by referring to the following.
Start > [Set] > Network and Internet > Ethernet > Network and Sharing Center >
Enable Network Discovery in Change Shared Advanced Settings > Click Save
Change.
384