i-PRO WV-U85402-V2L User Manual page 367

4 Advanced settings
4.11 Networking configuration [Network]
IPv4 network
[Network Settings]
Select how to set the IP address.
[Static]:Enter the IP address into the [IP address(IPv4)] to set the IP address.
[DHCP]:Set the IP address using the DHCP function. If you cannot obtain an IP address from the
DHCP server, set the IP address to 192.168.0.10. Subsequently, if you obtain an IP address from
a DHCP server, you change it to the IP address.
[Auto(AutoIP)]:Set the IP address using the DHCP function. If the DHCP server is not found, the
IP address is automatically configured.
[Auto(Advanced)]:Using the DHCP function, refer to the network address information and set the
unused IP address to the camera as the fixed IP address. The camera automatically determines the
set IP address within the range of the subnet mask. If the DHCP server is not found, set the IP
address to 192.168.0.10.
[IP address(IPv4)]
When the DHCP function is not used, enter the IP address of the computer. Do not overlap with
the IP address set on the PC or other network camera.
[Subnet mask]
When the DHCP function is not used, enter the subnet mask of the computer.
[Default gateway]
If you do not use the DHCP function, enter the default gateway for your computer.
[Note:]
・If the IP address cannot be retrieved from the DHCP server in AutoIP, search for
the IP address that is not used in the same network between 169.254.1.0 and
169.254.254.255 and set the IP address.
・[MULTI_PTZ] In DHCP/Auto setting (Omakase), if the DHCP server is not
found, set the IP address of the PTZ camera to 192.168.0.10 and the IP address of
the Multi-directional camera to 192.168.0.11.
[Note:]
・Multiple IP addresses are not available even when the DHCP function is used.
Contact your network administrator for the DHCP server configuration.
362