Setting Up Https - i-PRO WV-U85402-V2L User Manual

4 Advanced settings
4.11 Networking configuration [Network]
For the model supporting *PoE+ power supply, LLDP including TLV with checks in the following
table is sent for PoE+ power supply even if set to [Off].
Fabric Attach authentication key
Enter the key to be used for Fabric Attach authentication. It is valid only when [LLDP] is [On].
Number of characters that can be entered:0 to 32 characters (blank if not Fabric Attach
authentication)
Input Characters:One-byte alphanumeric characters
4.11.3

Setting up HTTPS

Here, you set up HTTPS to encrypt camera access and enhance communication security.
HTTPS can be configured using pre-installed certificates on the camera body or using CA (CA)
certificates obtained between the customer and the certification authority.
HTTPS setting method (pre-installation) is shown on the support video page of the support site.<
Control No. P0002>. To configure HTTPS (CA certificate),please refer to <Control No. P0003>.
[Note:]
・Press [Set] to restart the computer. After restarting, the product cannot be
operated for about two minutes as it was when the power was turned on.
・Information on devices that can be connected via Fabric Attach can be found on
our technical information website.
[Note:]
・[MULTI_PTZ] When the HTTPS connection is accessed, only the camera
accessed is protected.
397