R&G ECC0285 RHS Fitting Instructions Manual page 4

Page 4 of 13
Picture 4
Right Hand Side (as you sit on the bike)
• Remove the push rivets and the fairing bolts arrowed in pictures 2, 3, 4, 5 and
6. Then carefully remove the right-hand side fairing.
• Please ensure the engine is cold before proceeding with the fitment of the R&G
engine case cover.
• Remove the four bolts arrowed in picture 1, hold the cover up to the casing to
identify the correct bolts. DO NOT REMOVE ALL THE ENGINE CASE BOLTS.
• Offer the R&G cover up to the engine case and carefully fit over the casing.
Please ensure that the four bolt holes in the cover are aligned with the holes in
the engine case and then push on as far as it will go.
• Fit the specified bolts through the cover and into the engine case (please see
picture 1).
• Using a 5mm Allen key or socket bit tighten the bolts evenly to pull the cover into
position. DO NOT FULLY TIGHTEN AT THIS STAGE.
• Finally use a torque wrench set at 10 N/m (7lb/ft) to fully tighten.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Picture 6
FITTING INSTRUCTIONS
R&G
www.rg-racing.com
ECC0285
Picture 5
Email: info@rg-racing.com