Page 1
Page 1 of 9 ECC0287R FITTING INSTRUCTIONS FOR ECC0287R LHS ALTERNATOR COVER FOR BMW S1000RR ’19- THIS KIT CONTAINS THE ITEMS PICTURED AND LABELLED BELOW. DO NOT PROCEED UNTIL YOU ARE SURE ALL PARTS ARE PRESENT. LEASE NOTE THAT THE WAY THE KIT IS PACKED DOES NOT NECESSARILY REPRESENT THE WAY OF...
Page 3
Page 3 of 9 ECC0287R Picture 5 • Please make sure the engine is cold before proceeding with the fitting of the R&G cover. • Remove the fairing bolts shown in pictures 1-3 using a T25 key/socket, then gently pull the fairing back to give access to the engine case bolts.
Page 4
Page 4 of 9 ECC0287R ISSUE 1 – 29/07/2019 (FB) CONSUMER NOTICE The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design changes which do not diminish their performance or visual appeal and supplying them in such state shall conform to the order.
Page 5 of 9 ECC0287R NOTICE DE MONTAGE POUR ECC0287R PROTECTION ALTERNATEUR CÔTÉ GAUCHE POUR BMW S1000RR ’19- E KIT CONTIENT LES ARTICLES EXPOSES CI DESSOUS VERIFIER QUE TOUTES LES PIECES SOIENT PRESENTES AVANT DE PROCEDER AU MONTAGE A FAÇON DONT LE KIT EST EMBALLE NE CORRESPOND PAS FORCEMENT A LA FAÇON DE MONTER LES PIECES SUR...
Page 6 of 9 ECC0287R Item 2 = 3x M6 x 45mm Boulons E KIT CONTIENT Item = 1x Article 1 = 1x Protection alternateur avec entretoises & slider montés (PC0287R) NOTICE DE MONTAGE Assurez-vous que le moteur soit froid avant de commencer l’installation.
Page 7
Page 7 of 9 ECC0287R MONTAGEANLEITUNG FÜR ECC0287R ABDECKUNG LINKE SEITE (LICHTMASCHINE) - BMW S1000RR ’19- ALLE KIT-TEILE SIND UNTEN ABGEBILDET UND GEKENNZEICHNET. ÜBERPRÜFEN SIE, DASS ALLE TEILE VORHANDEN SIND, BEVOR SIE MIT DER MONTAGE BEGINNEN. HINWEIS: DIE VERPACKUNG DER TEILE STELLT NICHT DIE REIHENFOLGE DER MONTAGE DAR.
Page 8
Page 8 of 9 ECC0287R SIE BENÖTIGEN FOLGENDES WERKZEUG • T25 & T30 Torx-Schlüssel • 5mm Inbusschlüssel ALLGEMEINE ANZUGSDREHMOMENTE INHALT DES KITS M4 SCHRAUBE = 8Nm Artikel 1 = Abdeckung für Lichtmaschine mit M5 SCHRAUBE = 12Nm vormontierten Distanzhaltern und...
Page 9
Page 9 of 9 ECC0287R • Mit Abbildung 5 als Referenz, vorsichtig die R&G Abdeckung an das Motorgehäuse ansetzen und drüber schieben. Achten Sie darauf, dass die drei R&G Schrauben ausgerichtet sind, dann die Abdeckung soweit wie möglich eindrücken. •...