R&G ECG0002BK Fitting Instructions

FITTING INSTRUCTIONS FOR ECG0002BK ENGINE CASE GUARD
HONDA CRF250L AND M 2013 (RIGHT HAND SIDE ONLY)
Please note that the way the kit is packed does not necessarily represent the way of mounting to the bike
You will need 8mm socket and a 4mm Allen key and torque wrench to complete the fitment of this
product
Left-hand side (as you sit on bike)

Remove three M6 bolts as arrowed above left.

Insert new button head screws through the guard.

Place the three spacers over the bolts as shown above right (please note the smaller bolt and spacer are
used in the central hole).

Offer up to bike.

Tighten evenly to manufactures specified torque.

Fit sticker as shown above.
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design
changes which do not diminish their performance or visual appeal and supplying them in such state shall conform to the order.
The Buyer acknowledges no representation or warranty (other than as to title) has been given or will apply to the Products other
than those in R&G's order or confirmation and the Buyer confirms it has chosen the Products as being of merchantable quality
and suitable for its particular purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable
skill and care and rectify any fault free of charge unless the workmanship has been disturbed. The Buyer is responsible for
ensuring that the warranty on the motorcycle is not affected by the fitting of the Products. On return of any defective Products
R&G shall at its option either supply a replacement or refund the purchase money but shall not be liable if the Products have
been modified or used or maintained otherwise than in accordance with R&G's or manufacturer's instructions and good
engineering practice or if the defect arises from accident or neglect. Other than identified above and subject to R&G not limiting
its liability for causing death and personal injury, it shall not be liable for indirect or consequential loss and otherwise its liability
shall be limited to the amounts paid by the Buyer for the Products or the fitting or service concerned. These terms do not affect
the Buyer's statutory rights.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
CONSUMER NOTICE
R&G Racing
www.rg-racing.com Email: info@rg-racing.com