Table of Contents
Advertisement
Installation
Installing the appliance
Two people are required to install
the appliance.
The appliance must be empty
when it is installed.
Move the appliance carefully on
floors that are sensitive to scratching
to prevent damage.
For easier installation, there are trans-
port handles on the back at the top of
the appliance and transport wheels
underneath.
Wall gap
The declared energy consumption will
be achieved if a wall gap of at least 2"
(51 mm) is maintained between the
back of the appliance and the wall.
A smaller wall gap will not affect the
functionality of the appliance, but it
will increase energy consumption
slightly.
76
Fitting the anti-tip device
Danger of injury!
Due to the sheer size and weight of
the appliance, it needs to be ensured
that it cannot tip forward when the
door is open and fully stocked.
Set up the appliance with the sup-
plied anti-tip devices as described
below.
Caution! The water line or power
supply could get damaged.
Please ensure that neither the water
line nor the power supply are located
in this area, as these could be dam-
aged during installation e.g., by
screws.
The screws for fastening the anti-tip
device and the spacer (if required) are
not supplied with the appliance. Fas-
teners must be used that are suitable
for the wall and floor material (wood,
concrete, etc.).
Advertisement
Table of Contents
